Create a Bonsai: Wire Theory and Application

So you purchased (or placed) a tree in a pot.. Now what?

Depending on the season of the year, the type of tree, and the health of the tree, the fastest and most satisfying answer may be to put wire on the branches, and to form the branches into the shapes that you are envisioning.

Wired and bent branch

Wire should lay on the branch in a spiraling pattern. Generally, good technique is to shoot for a 45 to 60 degree angle in relation to the direction of the branch. This gives the wire good strength to bend in all directions.

We must plan the application of the wire in a way that we create solid, un-moving start to the wire.

A broken branch (right) makes a great anchor

This “anchor” will allow the branch to bend and not be able to spring back to its original position. This takes significant technique and practice to master. Surprisingly (or not), I have some examples of a bad anchor.

Note the gap on the left

A bad anchor, like this one, can allow the branch to spring back to its original position, or even damage the branch in some cases. Wire is also there to support your branch! My teachers would tell me to take it off and try again. Sorry!

The next step in wiring is to properly apply the wire to the branch. Just like the anchor, you must plan ahead when attempting to wire a branch. You need to avoid the foliage, and also allow space for you to wire secondary (branches coming off of the main branch that you are wiring), and tertiary branches (branches coming off of the secondary branches).

When doing the actual application of the wire, you should always be using both of your hands. Reach up from the bottom of the tree or branch. After creating your anchor, pin it to a strong base just before extending onto the branch.

Held tight to back with left index, pinned to front side with thumb, applied to branch with right index.

Once you have a couple of wraps around the branch, you can move your off-hand onto the branch.

Now we apply the wire to the branch. Hold the wire firmly on the branch with your off-hand a couple of turns behind where you are applying.

Push in the opposite direction with your off-hand

Then hold the wire a ways out from the branch with your wiring hand and move in roughly straight lines, effectively making triangles around the branch. This is what you should end up with.

Ignore the poor application in the foreground 🙂

Notice that there’s space next to the secondary branches. This is why!

Wired main and secondary branches

To wire secondary branches, you use the exact same theory. Create an anchor (in this case, another secondary branch), use your off-hand to support the wire and the branch a few turns back, straight lines.

We’ll go over how to bend a branch and make it look good in a later post.

I’d like to cap this off by stating that I know the theory of wire pretty well. I’m still in the beginner stages of being able to do things like finding the best anchor, choosing which branches to pair, avoiding secondary branches and foliage, allowing room for secondary wire, physical application, etc. If you found this interesting and want to go further into those deeper aspects, check out the links at the top of my page.

One thought on “Create a Bonsai: Wire Theory and Application

Leave a Reply to africanbirding Cancel reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: